Regency F37-LPG Installation Manual

FPI FIREPLACE PRODUCTS INTERNATIONAL LTD. 6988 Venture St., Delta, BC Canada, V4G 1H4918-677eMODELS: U32-NG5 Natural Gas U32-LP5 Prop

10U32-5 FPI Direct Vent Gas InsertINSTALLATIONVENTINGTHE APPLIANCE MUST NOT BE CONNECTED TO ACHIMNEY FLUE SERVING A SEPARATE SOLID FUELBURNING APPLIAN

U32-5 FPI Direct Vent Gas Insert11INSTALLATIONOPTIONAL BRICK PANEL1) Unwrap the brick pattern panels from the protective wrapping.2) Remove the glas

12U32-5 FPI Direct Vent Gas InsertINSTALLATIONLOG SET INSTALLATIONLog kit (Part # 425-930) contains the following pieces: a) 27-31 Rear Log b) 27-32

U32-5 FPI Direct Vent Gas Insert13INSTALLATION6) Fit the groove in log 27-34 into the tab on the right side of the burner. Rest the other end of log

14U32-5 FPI Direct Vent Gas InsertINSTALLATION8) Fit log 27-36 into the pins on logs 27-33 and 27-31.9) Place embers along the front of the burner a

U32-5 FPI Direct Vent Gas Insert15INSTALLATIONCompleted Log Set Installation27-3327-3227-3127-3627-3427-35

16U32-5 FPI Direct Vent Gas InsertINSTALLATIONDiagram 3Rear View: Trim AssemblyDiagram 2Rear View: Faceplate AssemblyDiagram 1REGENCY FACEPLATE &

U32-5 FPI Direct Vent Gas Insert17INSTALLATIONTo remove the fl ush door, reverse the above steps.NOTE: The chain must rest on TOP of the gas inlet pipe

18U32-5 FPI Direct Vent Gas InsertINSTALLATIONTHIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTERIF IN DOUBT DO NOT DO THIS CONVERSION !!1) Shut o

U32-5 FPI Direct Vent Gas Insert19INSTALLATIONInstallation of the DC Sparker:16) Verify that if the conversion is from NG to LPG, the screw must be

2U32-5 FPI Direct Vent Gas InsertTO THE NEW OWNERCongratulations! You are the owner of a state-of-the-art Gas Insert by FPI.The FPI Gas Insert Series

20U32-5 FPI Direct Vent Gas InsertINSTALLATION27) Run the other end of the ground wire and DC spark generator wires through the bushing on the heat s

U32-5 FPI Direct Vent Gas Insert21INSTALLATIONFULL SCREEN DOORS1) Hold the full screen door frame up against the unit in order to make the following

22U32-5 FPI Direct Vent Gas InsertINSTALLATION5) Place Bottom Frame near hinge. Flip hinge over Bottom Frame and secure with 3 screws.4) Install Spr

U32-5 FPI Direct Vent Gas Insert23INSTALLATION3) Position faceplate on unit lining up screw holes on faceplate with screw holes on unit - sec

24U32-5 FPI Direct Vent Gas InsertINSTALLATION7) Install the door frame by hooking the top fl ange over the top of the glass door.9) Run supplied 120

U32-5 FPI Direct Vent Gas Insert25INSTALLATIONThe Hearth Trim is an option that can be used to fi nish off the installation when the bottom of the fi re

26U32-5 FPI Direct Vent Gas InsertINSTALLATION3) Connect the female ends of the ON/OFF switch - to the ON/OFF switch in the control box.1) Attach t

U32-5 FPI Direct Vent Gas Insert27INSTALLATION9) Install the top door pressure retainer, required.10) Take the outer faceplate, line up the openings

28U32-5 FPI Direct Vent Gas InsertINSTALLATIONOPTIONAL HEARTH TRIMINSTALLATIONHearth Trim is an option that can be used to fi nish off the installation

U32-5 FPI Direct Vent Gas Insert29INSTALLATIONOPTIONAL REMOTE CONTROL Use the FPI Remote Control Kit approved for this unit. Use of other systems may

U32-5 FPI Direct Vent Gas Insert3Note: Oversize faceplate is 44" x 28"This FPI Mobile/Manufactured Home listed appliance comes equipped with

30U32-5 FPI Direct Vent Gas InsertINSTALLATIONPiezoIgnitorBlackRedToThermocouple INPilotAssemblyThermostat(Optional)(Millivolt)RemoteReceiver(Optional

U32-5 FPI Direct Vent Gas Insert31INSTALLATIONFor PROPANE Units and Units Equipped with DC Spark Boxes**For installation of the DC Spark Box refer to

The glass panel may require cleaning after the unit has cooled down. DO NOT ATTEMPT TO CLEAN THE GLASS WHILE IT IS HOT. Note: When the glass is cold

U32-5 FPI Direct Vent Gas Insert3333OPERATING INSTRUCTIONSCOPY OF LIGHTING INSTRUCTION PLATEsounds. You should also be aware that as there are tempera

GENERAL VENT MAINTENANCEConduct an inspection of the venting system semi-annually. Recommended areas to inspect as follows:1) Check the Venting Syste

U32-5 FPI Direct Vent Gas Insert35MAINTENANCEFAN MAINTENANCEIf your fan requires maintenance or replacement, access to the fan is through the plate on

36U32-5 FPI Direct Vent Gas InsertMAINTENANCEVALVE REPLACEMENT1) Shut off the gas supply.2) Remove the louvers (and bay door if it is on).3) Open t

2121BRICK PANEL SET36343312444242464547485043513635312517718131915141681052539411) 420-122 Fan Access Panel2) 420-142 Gasket - Fan Access Panel 422

38U32-5 FPI Direct Vent Gas InsertPARTS LIST 423-574/P Valve Assembly - NG 423-576/P Valve Assembly - LP52) 910-478 Valve - SIT NG / LP53) 910-

U32-5 FPI Direct Vent Gas Insert39PARTS LISTFLUSH FRONT149137112112112140112137137135139137FLUSH FRONT ASSEMBLY Part # Description

4U32-5 FPI Direct Vent Gas Insert4TABLE OF CONTENTSOPERATING INSTRUCTIONSOperating Instructions ...32Lig

40U32-5 FPI Direct Vent Gas InsertPARTS LISTLOGOPLATEHERELOGOPLATEHERELOGOPLATEHERELOGOPLATEHERE9295STANDARD SIZEDETAIL 'A'9193REAR VIEWFRON

U32-5 FPI Direct Vent Gas Insert41PARTS LISTCONTEMPORARY FACEPLATE AND DOORFRAME Part # Description3121) 425-512 Door Bottom Assembly2)

42U32-5 FPI Direct Vent Gas InsertPARTS LISTLOW PROFILE FACEPLATE Part # 425-924 Description124351) * Backplate Assembly2) *

U32-5 FPI Direct Vent Gas Insert43WARRANTYFireplace Products are designed with reliability and simplicity in mind. In addition, our internal Quality A

Printed in CanadaFPI, Regency® and Hampton® are trademarks of FPI Fireplace Products International Ltd.© Copyright 2012, FPI Fireplace Products Intern

U32-5 FPI Direct Vent Gas Insert5SAFETY LABELThis is a copy of the labels that accompany each U32-5 Gas Insert. We have printed a copy of the contents

6U32-5 FPI Direct Vent Gas InsertREQUIREMENTS5.08: Modifications to NFPA-54, Chapter 10(2) Revise 10.8.3 by adding the following additional requiremen

U32-5 FPI Direct Vent Gas Insert7INSTALLATIONIMPORTANT MESSAGE SAVE THESE INSTRUCTIONSThe U32 Gas Insert must be installed in accordance with these i

8U32-5 FPI Direct Vent Gas InsertINSTALLATIONIMPORTANT MESSAGE SAVE THESE INSTRUCTIONSThe FPI Gas Insert must be installed in accordance with these

U32-5 FPI Direct Vent Gas Insert9INSTALLATIONDMANUFACTURED MOBILE HOME ADDITIONAL REQUIREMENTS1) Ensure that structural members are not cut or we