Regency PT030-LP1 Installation Manual

WARNING: If the information in these instructions are not followed exactly, a fi re or explosion may result causing property damage, personal injury

Regency® E33S-1 Sunrise Gas Insert 10INSTALLATIONINSTALLATIONVENTINGTHE APPLIANCE MUST NOT BE CONNECTED TO A CHIMNEY FLUE SERVING A SEPARATE SOLID FUE

Regency® E33S-1 Sunrise Gas Insert 11INSTALLATIONINSTALLATIONGAS PIPE PRESSURE TESTINGThe appliance must be isolated from the gas supply piping syste

Regency® E33S-1 Sunrise Gas Insert 12INSTALLATION1) Turn off the gas supply.2) Remove the glass door. E33S only: a) Remove the 2 screws at

Regency® E33S-1 Sunrise Gas Insert 13INSTALLATIONINSTALLATION7) Remove burner orifi ce with a 1/2" wrench and discard.8) Install the new LP bur

Regency® E33S-1 Sunrise Gas Insert 14INSTALLATIONInstallation of the DC Sparker:1) Locate the Piezo Ignitor situated at the side of valve.Piezo Ignit

Regency® E33S-1 Sunrise Gas Insert 15INSTALLATION14) Tie up the loose wire with the wire clip.13) Find a location which is not too hot and is easy

Regency® E33S-1 Sunrise Gas Insert 16INSTALLATIONWIRING DIAGRAMSThis heater does not require a 120V A.C. supply for operation. However, a 120V A.C. p

Regency® E33S-1 Sunrise Gas Insert 17INSTALLATIONUse the FPI Remote Control Kit approved for this unit. Use of other systems may void your warranty.T

Regency® E33S-1 Sunrise Gas Insert 18INSTALLATIONINSTALLATIONOPTIONAL REFLECTIVE PANEL INSTALLATIONBefore installation, panels must be handled and cle

Regency® E33S-1 Sunrise Gas Insert 19INSTALLATIONINSTALLATION10) After the top panel has been secured - install the back panel. The back pane

Regency® E33S-1 Sunrise Gas Insert 2FPI GAS FIREPLACE INSERTTO THE NEW OWNERCongratulations! You are the owner of a state-of-the-art Gas Insert by FP

Regency® E33S-1 Sunrise Gas Insert 20INSTALLATIONINSTALLATION13) Re-install fi rebox base.14) Re-install pilot assembly cover.15) Re-install burner.16

Regency® E33S-1 Sunrise Gas Insert 21INSTALLATIONGLASS DOOR INSTALLATIONTo install the glass door, simply hook the top door fl ange onto the top of th

Regency® E33S-1 Sunrise Gas Insert 22INSTALLATIONCONTEMPORARY FACEPLATE &DOOR FRAME INSTALLATION1) Bring the faceplate up in front of the unit an

Regency® E33S-1 Sunrise Gas Insert 23INSTALLATION6) Place 2 screws through the screw holes on the hinge and place a spacer over each screw.7) Secur

Regency® E33S-1 Sunrise Gas Insert 24INSTALLATION1) Attach the inner faceplate panel to the insert body using 4 screws in the locations shown below.D

Regency® E33S-1 Sunrise Gas Insert 25INSTALLATIONDiagram 9Outer faceplateInner faceplatepanel pinsDiagram 108) Attach the bottom louver to the 2 hin

Regency® E33S-1 Sunrise Gas Insert 26INSTALLATIONOPTIONAL HEARTH TRIMINSTALLATIONThe Hearth Trim is an option that can be used to fi nish off the insta

Regency® E33S-1 Sunrise Gas Insert 27OPERATIONOPERATING INSTRUCTIONSIMPORTANT: Gas on/off knob cannot be turned from "PILOT" to "OFF&q

Regency® E33S-1 Sunrise Gas Insert 28OPERATIONOPERATING INSTRUCTIONSCOPY OF LIGHTING INSTRUCTION PLATEAUTOMATIC CONVECTION FAN OPERATIONThe fan opera

Regency® E33S-1 Sunrise Gas Insert 29MAINTENANCEMAINTENANCEGENERAL VENT MAINTENANCEConduct an inspection of the venting system semi-annually. Recomme

Regency® E33S-1 Sunrise Gas Insert 3TABLE OF CONTENTSSAFETY LABELCopy of Safety Decal ...4REQUIREME

Regency® E33S-1 Sunrise Gas Insert 30MAINTENANCEMAINTENANCEVALVE TRAY REPLACEMENT1) Turn the unit off and allow it to cool down to room temperature.2

Regency® E33S-1 Sunrise Gas Insert 31MAINTENANCE8) Remove the base cover by lifting up from the back and maneover out.Base Cover9) Disconnect the O

Regency® E33S-1 Sunrise Gas Insert 32MAINTENANCEFAN REPLACEMENT8) Remove the base cover by lifting up from the back and maneover out.6) Remove the b

Regency® E33S-1 Sunrise Gas Insert 33MAINTENANCE9) Remove the fan access plate by undoing the 12 screws shown.10) Remove the 2 screws that hold the

Regency® E33S-1 Sunrise Gas Insert 34PARTS LIST1394948217181951378AIRINAIRINAETHTPTPTHTPTHOOTLIP56575982525554676679PARTS LISTMAIN ASSEMBLY Pa

Regency® E33S-1 Sunrise Gas Insert 35PARTS LISTPARTS LISTACCESSORIES Part # Description

Regency® E33S-1 Sunrise Gas Insert 36PARTS LISTLOW PROFILE FACEPLATE Part # Description1) * Backplate Assembly2) *

Regency® E33S-1 Sunrise Gas Insert 37NOTES

Regency® E33S-1 Sunrise Gas Insert 38NOTES

Regency® E33S-1 Sunrise Gas Insert 39WARRANTYRegency Fireplace Products are designed with reliability and simplicity in mind. In addition, our intern

Regency® E33S-1 Sunrise Gas Insert 4INSTALLATIONSAFETY LABELThis is a copy of the safety label that accompanies the E33 SunriseTM Gas Insert. We have

Regency® E33S-1 Sunrise Gas Insert 40Installer: Please complete the following informationDealer Name & Address: __________________________________

Regency® E33S-1 Sunrise Gas Insert 5INSTALLATIONREQUIREMENTS5.08: Modifications to NFPA-54, Chapter 10(2) Revise 10.8.3 by adding the following addit

Regency® E33S-1 Sunrise Gas Insert 6INSTALLATIONUNIT DIMENSIONS32-1/8” (816mm)47-1/2” (1207mm)11-3/8”(290mm)1-1/8”(28mm)2-7/8”(72mm)16-1/2” (419mm)16-

Regency® E33S-1 Sunrise Gas Insert 7INSTALLATIONINSTALLATIONIMPORTANT MESSAGE SAVE THESE INSTRUCTIONSThe FPI Gas Insert must be installed in accord-a

Regency® E33S-1 Sunrise Gas Insert 8INSTALLATIONINSTALLATION11) Due to high temperatures, the appliance should be located out of high traffi c areas an

Regency® E33S-1 Sunrise Gas Insert 9INSTALLATIONINSTALLATIONMINIMUM CLEARANCES TO COMBUSTIBLES From Unit Side Walls