Regency MX Excel Owner's Manual

• MX EXCEL •• CEILING FAN OWNER'S MANUAL • WARNING: Read and follow these instructions carefully and be mindful of all warnings shown throughout.

8ELECTRICAL CONNECTIONSELECTRICAL CONNECTIONS: Be sure electricity is turned off at the main power box before wiring1. Four wires are connected to th

BLADE ATTACHMENT9BLADE ATTACHMENT:Fig. 51. Place fiber washer on screw. Insert this assembly through the blade and start the screw into the blade arm

10INSTALLATION OF REMOVABLE SWITCH HOUSINGNOTE: Be sure the power is off before installing.1. Loosen the 3 side screws on switch housing hub halfway.2

OPERATION11Tu rn on the power and check operation of the fan. The fan is controlled by the use of the fan speed pull chain as follows:one pull = high

5/04 Regency Ceiling FansTHANK YOU FOR PURCHASING A REGENCY CEILING FAN.Write to us at:Regency Ceiling FansP. O. Box 730Fenton, MO 63026Visit us on th

GENERAL INSTALLATION & OPERATION INSTRUCTIONSIMPORTANT SAFEGUARDS:1. To ensure the success of the installation, be sure to read the instructions a

Warnings:• Disconnect power by removing fuse or turning off circuit breaker before installing the fan and/or optionallighting. Support directly from b

UNPACKING YOUR FAN1. Unpack your fan and check the contents. Do not discard the carton. If warranty replacement or repair is ever necessary, the fan s

PREPARATION:Verify you have all parts before beginning the installation. Check foam insert closely for missing parts. Remove motorfrom packing. To avo

INSTALLING THE FAN4This fan has three installation options:INSTALLATION:The 3˝ DOWNROD or HUGGER methods are preferred if maximum headroom is required

INSTALLING THE FAN - HUGGER STYLENOTE: The S hook is to be used for hugger style mounting.1. Remove the plastic trim ring from the canopy to expose th

6INSTALLING THE FAN WITH A DOWNROD1. Carefully support fan body (motor) in its styrofoam packing with the mounting collar (where the wires come out)fa

7INSTALLING THE FAN WITH A DOWNROD1. Lift ball/downrod/fan into hanger bracket opening. NOTE: The tab opposite hanger bracket opening should fit inslo