Regency Professional Series Owner's Manual

• PROFESSIONAL SERIES FANS •• CEILING FAN OWNER'S MANUAL • WARNING: Read and follow these instructions carefully and be mindful of all warnings s

1. Lift ball/downrod/fan into hanger bracket opening. NOTE: The tab opposite hanger bracket opening should fit inslot on ball.2. Make wire connections

ELECTRICAL CONNECTIONS: Be sure electricity is turned off at the main power box before wiringELECTRICAL CONNECTIONS91. Four wires are connected to th

10BLADE ATTACHMENTBLADE ATTACHMENT:Blade to motor screwand metal lock washerBlade assemblyFig. 21. Place fiber washer on screw. Insert this assembly

11Side Screw (x3)Switch HousingConnector (plug) with Side BuckleSwitch Housing Hub(bottom of motor)Keyhole Slot (x3)Connector (receptacle)Pull ChainRe

12INSTALLATION OF LIGHT KITNOTE: Before installing the switch housing to the fan, the light fixture should be installed onto the switch housing. 1. R

Turn on the power and check operation of the fan. The fan is controlled by the use of the pull chain as follows:one pull = high speedtwo pulls = mediu

Periodic cleaning of your new ceiling fan is about the only maintenance that is needed. Only use a soft brush or lint freecloth to avoid scratching th

THANK YOU FOR PURCHASING A REGENCY CEILING FAN.Write to us at:Regency Ceiling FansP.O. Box 730Fenton, MO 63026Visit us on the Web at: www.regencyfan.c

RReeggeennccyy CCeeiilliinngg FFaannLLiimmiitteedd LLiiffeettiimmee WWaarrrraannttyyRegency extends the following warranty to the original purchaser o

GENERAL INSTALLATION & OPERATION INSTRUCTIONSIMPORTANT SAFEGUARDS:1. To ensure the success of the installation, be sure to read the instructions a

Warnings:• Disconnect power by removing fuse or turning off circuit breaker before installing the fan and/or optionallighting. Support directly from b

UNPACKING YOUR FAN1. Unpack your fan and check the contents. Do not discard the carton. If warranty replacement or repair is ever necessary, the fan s

PREPARATION:Verify you have all parts before beginning the installation. Check foam insert closely for missing parts. Remove motorfrom packing. To avo

INSTALLING THE FAN5This fan has two installation options:INSTALLATION:The HUGGER method is preferred if maximum headroom is required. The ceiling must

INSTALLING THE FAN - HUGGER STYLENOTE: The S hook is to be used for hugger style mounting.1. Remove the plastic trim ring from the canopy to expose th

1. Carefully support fan body (motor) in its styrofoam packing with the mounting collar (where the wires come out)facing upward.2. Remove ball from do