Regency Regatta Owner's Manual

• REGATTA •• CEILING FAN OWNER’S MANUAL•WARNING: Read and follow these instructions carefully and be mindful of all warnings shown throughout.3/04

9INSTALLATION OF REMOVABLE SWITCH HOUSINGNOTE: Be sure the power is off before installing.1. Loosen the 3 side screws on switch housing hub halfway.2.

STANDARD REMOTE CONTROL (OPTIONAL-NOT INCLUDED)GENERAL INFORMATIONNOTE: For use with a standard remote control.Multiple code choices are included with

3. After you have preset the code selectors, insert the terminal connector from the fan motor into the terminal connector inside the receiver (Fig. 2)

Forward/Reverse Direction:Forward is a counterclockwise rotation of the bladeswhen viewed from beneath the fan. This will create adownward breeze that

THANK YOU FOR PURCHASING A REGENCY CEILING FAN.Write to us at:Regency Ceiling FansP. O. Box 730Fenton, MO 63026Visit us on the Web at: www.regencyfan.

GENERAL INSTALLATION & OPERATION INSTRUCTIONSIMPORTANT SAFEGUARDS:1. To ensure the success of the installation, be sure to read the instructions

WARNINGS:* Disconnect power by removing fuse or turning off circuit breaker before installing the fan and/or optional lighting.* Support directly from

1. Unpack your fan and check the contents. Do not discard the carton. If warranty replacement or repair is ever necessary, the fan should be returned

PREPARATION:Verify that you have all parts before beginning the installation. Check foam insert closely for missing parts. Remove motor frompacking. T

ASSEMBLY INSTRUCTIONS: DOWNROD, CANOPY, AND COLLAR COVER1. Carefully support fan housing (motor) in its styrofoam packing with the mounting collar (wh

6INSTALLING THE FANWARNING: To avoid damaging the blade arms and blades, do not install blades onto fan until fan is fastened to ceiling.If arms are

ELECTRICAL CONNECTIONS: Be sure electricity is turned off at the main power box before wiringELECTRICAL CONNECTIONS7WiringboxLightSwitchBLKBLUEWHFan c

1. Place fiber washer on screw. Insert this assembly through the blade and start the screw into the blade arm. Repeatthis procedure without tightening