FPI FIREPLACE PRODUCTS INTERNATIONAL, LTD. 6988 Venture St., Delta, BC, Canada V4G 1H4GCI60-0804/19/2011GCI60TECHNICAL MANUALCast Iron Pellet Inser
InstallationclearanceS to combuStibleS:Figure 4: GCI60 Clearance to Combustibles. thermoStat inStallation:1. Install the wall thermostat (millivolt ra
hot enough to cause burns if touched by children. Non-combustible shielding or guards may be required.3. Termination must exhaust above the inlet ele
InstallationoutSide freSh-air connection:This Heater must have adequate air for proper combustion in the room that it is installed.A Fresh-air intake
InstallationInstallationmaSonry fireplace inStallation:A non-combustible manufactured hearth pad (min. 24 gauge galvanized steel or similar) must
InstallationpoSitive flue connection Without a full reline (uSa only):This unit does not require a full reline (in USA only) when installing into a ma
Installationbuilt-in inStallation:Installation without a masonry replace -The GCI60 can be installed without an existing masonry replace by building
Installationhorizontal exhauSt through Wall inStallation:Vent installation: install vent at clearances specified by the vent manufacturer.A chimney c
Installationrecommended - through Wall With vertical riSe and horizontal termination inStallation:Figure 12: Venting horizontally with rise. NOTE - Th
Figure 13: Outside Vertical Installation. InstallationoutSide vertical inStallationS:To accomplish an outside vertical pipe installation, follow the “
InstallationinSide vertical inStallationS:1. Install a tee or 90° elbow on the inside of the house.2. Install PL vent upward from the tee. Make sure
Hampton GCI60 Cast Pellet Insert Technical Manual2Safety Note:
InstallationSlider/damper Set-up:This is used to regulate the airflow through the pellet stove. Figure 15: Slider/Damper Plate & Rod in Unit.This
TroubleshootingDO NOT:● Service the stove with wet hands. The stove is an electrical appliance, which may pose a shock hazard if handled improperly.
Troubleshooting• Exhaust Temperature Sensor failure. Bypass sensor located on Exhaust Blower, if stove now operates properly, the unit may require cl
Troubleshooting7. The convection blower will not function normally. • Check the line fuse to see if it has blown.• Clean all grill openings at the b
Wiring DiagramIgnitorRedWhiteRedWhiteAir PumpExhaustTemperatureSensorBrownBrownHigh Limit TemperatureSwitchOrangeOrangePurpleWhiteConvectionBlowerAgit
Parts ListReference # Description Part #OPTION Log Set GC60-930OPTION Service Rails GCI60-900OPTION GCI60-9181 HOPPER SWITCH GC
Parts ListReference # Description Part #40 GC60-01041 GC60-01242 GC60-03043
Parts ListReference # Description Part #64 GCI60-201 GCI60-21166
Parts Diagram - Components6481234823141011159292174224125425171618405224541494752531319 2037Hampton GCI60 Cast Pellet Insert Technical Manual28
Parts Diagram - Steel697038285726276356261365159666768646530373944717273Hampton GCI60 Cast Pellet Insert Technical Manual 29
Safety Warnings & Recommendations...3Specifications...
Please Note - Burning Corn or Grains - Burning corn or other grains creates a harsher environment than burning wood pellets. The sugar in corn turns t
Hampton GCI60 Cast Pellet Insert Technical Manual 31WARRANTYExclusions and Limitations:
Hampton GCI60 Cast Pellet Insert Technical Manual32WARRANTY
Hampton GCI60 Cast Pellet Insert Technical Manual 33__________________________________________________________________________________________________
Hampton GCI60 Cast Pellet Insert Technical Manual34Printed in CanadaRegency, Hampton and Greenfire are registered and / or proprietary
Safety Warnings & Recommendations* This manual is designed for the technician in conjunction with the owner’s manual. *Please read this entire Tec
Safety Warnings & RecommendationsELECTRICAL: The use of a surge protected power bar is recommended. The unit must be grounded. The grounded electr
Specificationsrating label & location:The rating label is located on the top of the hopper.Figure 1: GCI60 Rating Label. Certified for use in Cana
SpecificationsdimenSionS:Figure 2: Dimensions of GCI60. Input rating when using: Wood Pellets/Corn - 55,000BTU (16.1KW•hr) & Wheat/Barley - 53,000
Installationdeciding Where to locate your pellet appliance:1. Unit must be installed in a masonry fireplace.2. Do not install the stove in a bedroom o
InstallationFigure 4: GCI60 Frame. inStalling the inSert frame & levelling:Warning: Careless installation is the major cause of safety hazards. C
Comments to this Manuals