Regency Horizon HZI234E Small Gas Insert User Manual

FPI FIREPLACE PRODUCTS INTERNATIONAL LTD. 6988 Venture St., Delta, BC, Canada V4G 1H4918-988WARNING: Improper installation, adjustment, alteration

10Regency® HZI234E Direct Vent Gas InsertINSTALLATIONIMPORTANT MESSAGE SAVE THESE INSTRUCTIONSThe FPI Direct Vent Gas Insert must be installed in acco

Regency® HZI234E Direct Vent Gas Insert11INSTALLATION11) Due to high temperatures, the appliance should be located out of high traffi c areas and away

12Regency® HZI234E Direct Vent Gas InsertINSTALLATIONMINIMUM CLEARANCES TO COMBUSTIBLES Side Walls A 8" (203 mm)* Cei

Regency® HZI234E Direct Vent Gas Insert13INSTALLATIONTHE APPLIANCE MUST NOT BE CONNECTED TO A CHIMNEY FLUE SERVING A SEPARATE SOLID FUEL BURNING APPLI

14Regency® HZI234E Direct Vent Gas InsertINSTALLATIONCONVERTING FROM 3" & 3" VENTING TO 3" & 2"1) Remove the top plate fr

Regency® HZI234E Direct Vent Gas Insert15INSTALLATIONGAS INSERT AERATION SYSTEMThe burner aeration is factory set but may need adjusting due to either

16Regency® HZI234E Direct Vent Gas InsertINSTALLATIONGAS PIPE PRESSURE TESTINGThe appliance must be isolated from the gas sup-ply piping system by clo

Regency® HZI234E Direct Vent Gas Insert17INSTALLATIONTHIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTERIF IN DOUBT DO NOT DO THIS CONVERSION !!Eac

18Regency® HZI234E Direct Vent Gas InsertINSTALLATION8) Remove the burner by removing 3 screws.9) Slide burner forward and lift up and out.16) Rein

Regency® HZI234E Direct Vent Gas Insert19INSTALLATION3) Attach the label “This unit has been converted to LPG” near or on top of the serial # decal.4

2Regency® HZI234E Direct Vent Gas InsertREGENCY GAS FIREPLACE INSERTTO THE NEW OWNERCongratulations! You are the owner of a state-of-the-art Gas Inse

20Regency® HZI234E Direct Vent Gas InsertINSTALLATIONGLASS CRYSTALS OR OPTIONAL CERAMIC STONESINSTALLATION ON BURNERGlass Crystals shown on BurnerFor

Regency® HZI234E Direct Vent Gas Insert21INSTALLATIONOPTIONAL PEBBLE / CRYSTAL INSTALLATIONFOR FIREBOX BASENatural River Pebbles shown surrounding the

22Regency® HZI234E Direct Vent Gas InsertINSTALLATIONREFLECTIVE PANEL INSTALLATION1) Remove the faceplate and glass door if already installed - see

Regency® HZI234E Direct Vent Gas Insert23INSTALLATIONGLASS DOOR REMOVAL / INSTALLATIONOPTIONAL SCREEN DOOR REMOVAL / INSTALLATION1) Remove the glass

24Regency® HZI234E Direct Vent Gas InsertINSTALLATIONLOW PROFILE FACEPLATE INSTALLATION(3 AND 4 SIDED)1) Install 4 screws on sides of unit - in locat

Regency® HZI234E Direct Vent Gas Insert25INSTALLATION11) Hook the front faceplate over the installed backing plate.12) Install the bottom louver by

26Regency® HZI234E Direct Vent Gas InsertINSTALLATIONCONTOUR & CONTEMPORARY FACEPLATEFaceplate Contents List:1 Faceplate (Contour or Contemporary

Regency® HZI234E Direct Vent Gas Insert27INSTALLATION7) Secure the loose wires into the wire clips above and to the bottom left of the battery pack a

28Regency® HZI234E Direct Vent Gas InsertINSTALLATIONDiagram 1113) Re-install the remote receiver bracket (reverse step 10).14) Close the left side fa

Regency® HZI234E Direct Vent Gas Insert29INSTALLATIONOPTIONAL BACKING PLATE3) Attach the top piece of the backing plate to the faceplate using 5 scre

Regency® HZI234E Direct Vent Gas Insert33TABLE OF CONTENTSSAFETY LABELCopy of safety decal...4REQUI

30Regency® HZI234E Direct Vent Gas InsertINSTALLATIONAttach Left & Right Backing Plate to Faceplate7) Align the screw holes on the left and right

Regency® HZI234E Direct Vent Gas Insert31INSTALLATIONOPTIONAL HEARTH TRIM-CONTOUR/STANDARD FACEPLATE1) Open the left and right side faceplate panels.

32Regency® HZI234E Direct Vent Gas InsertINSTALLATIONOPTIONAL HEARTH TRIM - LOW PROFILE FACEPLATE1) Align the screw holes on the hearth trim with the

Regency® HZI234E Direct Vent Gas Insert33INSTALLATIONPROFLAME REMOTE CONTROL RECEIVER INSTALLATION1) Remove faceplate if installed.2) From the rig

34Regency® HZI234E Direct Vent Gas InsertINSTALLATION6) Connect the wire harness to the back of the remote receiver; Place wire clip holder on the

Regency® HZI234E Direct Vent Gas Insert35INSTALLATIONCAUTIONDo not wire millivolt Thermostat wiresto 120V wire.Thermostat Wire TableRecommended Maximu

36Regency® HZI234E Direct Vent Gas InsertINSTALLATIONWIRING DIAGRAMThis heater does not require a 120V A.C. supply for operation. In case of a power f

Regency® HZI234E Direct Vent Gas Insert37INSTALLATIONAn optional AC power adaptor may be installed as a constant power source for the SureFire system.

38Regency® HZI234E Direct Vent Gas InsertINSTALLATIONFAN WIRING DIAGRAMCAUTION: Label all wires prior to disconnection when servicing controls. Wiring

Regency® HZI234E Direct Vent Gas Insert3939INSTALLATIONOPERATING INSTRUCTIONSOPERATING INSTRUCTIONS1) Read and understand these instructions before o

4Regency® HZI234E Direct Vent Gas Insert4SAFETY LABELSAFETY LABELThis is a copy of the labels that accompany each HZI234E Gas Insert. We have printed

40Regency® HZI234E Direct Vent Gas Insert40OPERATING INSTRUCTIONSCOPY OF LIGHTING PLATE INSTRUCTIONS918-628bA) This appliance is equipped with an ig

Regency® HZI234E Direct Vent Gas Insert41MAINTENANCE2) Remove the Termination Cap, and shine a fl ashlight down the Vent. Remove any bird nests, or ot

42Regency® HZI234E Direct Vent Gas InsertMAINTENANCEFAN REPLACEMENT1) Unplug the power source.2) Open the left and right side faceplate panels.3) R

Regency® HZI234E Direct Vent Gas Insert43MAINTENANCEGround WireFan Cover Plate Removal13) Remove 13 screws to remove the fan access plate.14) Lift

44Regency® HZI234E Direct Vent Gas InsertMAINTENANCE1) Shut off gas supply to unit and unplug the power source by disconnecting the batteries.2) Ope

Regency® HZI234E Direct Vent Gas Insert45PARTS LIST1 536-016 Door Frame2 536-517/P Fan Assembly3 536-532 Flue adaptor Assy4 536-539 Door Frame Assy5 5

46Regency® HZI234E Direct Vent Gas InsertPARTS LIST3 AND 4 SIDED LOW PROFILE FACEPLATE ASSEMBLY Part # Description 1 566-924 3 sid

Regency® HZI234E Direct Vent Gas Insert47PARTS LISTFACEPLATE ASSEMBLY Part # Description

48Regency® HZI234E Direct Vent Gas InsertPARTS LISTBACKING PLATE & HEARTH TRIM ASSEMBLY Part # Description 53

Regency® HZI234E Direct Vent Gas Insert49NOTES

Regency® HZI234E Direct Vent Gas Insert5REQUIREMENTS5.08: Modifications to NFPA-54, Chapter 10(2) Revise 10.8.3 by adding the following additional req

50Regency® HZI234E Direct Vent Gas InsertNOTES

Regency® HZI234E Direct Vent Gas Insert51WARRANTYRegency Fireplace Products are designed with reliability and simplicity in mind. In addition, our int

Printed in CanadaRegency and Horizon are trademarks of FPI Fireplace Products International Ltd.© Copyright 2011, FPI Fireplace Products International

6Regency® HZI234E Direct Vent Gas InsertDIMENSIONS20"510mm2918"739mm3278"836mm21532mm2278"581mm1"3"26mm[76mm]16"428

Regency® HZI234E Direct Vent Gas Insert7DIMENSIONSDIMENSIONS W/ LOW PROFILE 4 SIDED FACEPLATE20"510mm2918"739mm3278"836mm3014"770m

8Regency® HZI234E Direct Vent Gas InsertDIMENSIONS60°Contour FaceplateEIContemporary Faceplate27-3/4” (705mm)27-1/2” (699mm)19-1/2” (495mm)13” (330mm)

Regency® HZI234E Direct Vent Gas Insert9INSTALLATIONCLOTHING OR OTHER FLAMMABLE MATERIAL SHOULD NOT BE PLACED ON OR NEAR THE APPLIANCE. CHILDREN AND