Regency P121 User Manual download pdf (Page 10)

Regency

P121-2/P121LC-2/P121RC-2/P131-2 Zero Clearance Direct Vent Gas Fireplace

INSTALLATION

COMBUSTIBLE MANTELS

CLEARANCES

The clearances listed below are Minimum distances unless otherwise stated (refer to diagrams in the "Locating Your Fireplace" section):

WARNING:

Fire hazard is an extreme risk

if these clearances (air space)

to combustible materials are

not adhered to. It is of greatest

importance that this ﬁ replace

and vent system be installed

only in accordance with these

Clearance to Combustibles from:

Back 0" (0mm)

Side 0" (0mm)

Floor 0" (0mm)

CAUTION REQUIREMENTS: The top, back and sides of the ﬁ replace are deﬁ ned by standoffs.

The metal ends of the standoffs may NOT be recessed into combustible construction.

Determine the total thickness of the ﬁ nished ﬂ oor (eg. tile, carpet, slate) to allow the ﬁ nished

surface to be ﬂ ush with the base of the unit.

Ceiling Height from Floor 72" (1828mm)

Mantel Height from Base of Unit:

39" min. (991mm)

Horizontal Vent Clearances:

Top 2-1/2" (64mm)

Side 1-1/2" (38mm)

Bottom 1-1/2" (38mm)

Vertical Vent Clearances 1-1/4" (32mm)

Because of the extreme heat this ﬁ replace emits,

the mantel clearances are critical. Combustible

mantel clearances from top of unit are shown in

Diagram to the right.

Note: A non-combustible mantel may be

installed at a lower height if the framing

is made of metal studs covered with a

non-combustible board.

This drawing is to scale at 1:6 (one inch = 6

inches)

Mantel can be installed anywhere in shaded area

or higher using this scale.

Caution: Ensure the paint that is used on the

mantel and the facing

is "heat resistant" or the paint may

discolour.

* If the 3" (76mm) metal extension trim is removed

it must be replaced with a 8" (203mm) non-

combustible material.

Mantel Clearances

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 47 48

Comments to this Manuals

No comments

Regency P121 User Manual Page 10

Comments to this Manuals

Related products and manuals for Kiln Regency P121