Regency Energy U21 Small Gas Insert User Manual

WARNING: If the information in these instructions are not followed exactly, a fi re or explosion may result causing property damage, personal injury

10 Regency® E21-3 Gas Fireplace InsertINSTALLATIONCLEARANCES TO COMBUSTIBLESThe minimum clearance from the side of the appliance to a combustible side

Regency® E21-3 Gas Fireplace Insert11INSTALLATIONHIGH ELEVATIONThis unit is approved in Canada for altitude 0 to 4500 ft. (CAN/CGA 2.17-M91) with the

12 Regency® E21-3 Gas Fireplace InsertINSTALLATIONWIRING DIAGRAMSCAUTION: Label all wires prior to disconnection when servicing controls. Wiring err

Regency® E21-3 Gas Fireplace Insert13INSTALLATIONNote: Do not operate unit if fl ue connector is not fastened in original position.FLUE CONNECTOR INS

14 Regency® E21-3 Gas Fireplace InsertINSTALLATIONGAS PIPE PRESSURE TESTINGThe appliance must be isolated from the gas supply piping system by closing

Regency® E21-3 Gas Fireplace Insert15INSTALLATIONTEST FOR FLUE SPILLAGEA " spillage" test must be made before the installed unit is left wi

16 Regency® E21-3 Gas Fireplace InsertINSTALLATIONLOG SET INSTALLATIONLog kit (Part # 533-930) contains the following pieces: a) 27-23 Back Center L

Regency® E21-3 Gas Fireplace Insert17INSTALLATION6) Fit log 27-26 into the pins on the front right side of the burner.5) Rest the top of log 27-25

18 Regency® E21-3 Gas Fireplace InsertINSTALLATION8) Fit log 27-28 into the pin on the left side of the burner.9) Fit the left end of log 27-29 into

Regency® E21-3 Gas Fireplace Insert19INSTALLATIONCompleted Log Set Installation27-2311) Place embers along the front of the burner as shown. Ensure

2 Regency® E21-3 Gas Fireplace InsertCONGRATULATIONS!You are the owner of a state-of-the-art Gas Insert by:FPI FIREPLACE PRODUCTS INTERNATIONAL LTD.Th

20 Regency® E21-3 Gas Fireplace InsertINSTALLATIONDiagram 4Diagram 56) Connect the ON/OFF switch wires by taking the black and red wires with the fem

Regency® E21-3 Gas Fireplace Insert21INSTALLATIONFLUSH GLASS1) Install the bottom glass trim onto the glass support.2) Slide the glass into the bot

22 Regency® E21-3 Gas Fireplace InsertINSTALLATIONConversion Kit# 534-969 from NG to LPTHIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER IF IN DO

Regency® E21-3 Gas Fireplace Insert23INSTALLATION17) Verify that if the conversion is from NG to LPG, the screw must be re-assembled with the red o

24 Regency® E21-3 Gas Fireplace InsertINSTALLATIONInstaller Notice:These instructions must be left with the appliance.37) Check for gas leaks.38) Ch

Regency® E21-3 Gas Fireplace Insert25INSTALLATIONFULL SCREEN DOORS1) Hold the full screen door up against the unit in order to make the following wi

26 Regency® E21-3 Gas Fireplace InsertINSTALLATION6) Place Bottom Frame near hinge. Flip hinge over Bottom Frame and secure with 3 screws each.Bottom

Regency® E21-3 Gas Fireplace Insert27INSTALLATION1) Attach the inner faceplate panel to the insert body using 4 screws in the locations shown below.

28 Regency® E21-3 Gas Fireplace InsertINSTALLATIONDiagram 10Diagram 9Outer faceplateInner faceplatepanel pinsDiagram 117) Attach the bottom louver to

Regency® E21-3 Gas Fireplace Insert29INSTALLATIONHearth Trim is an option that can be used to fi nish off the installation when the bottom of the fi re

Regency® E21-3 Gas Fireplace Insert3INSTALLATION40-1/8"22-11/16"Low Profi le Faceplate Dimensions9-7/8”51* Standard size shown, custom size

30 Regency® E21-3 Gas Fireplace InsertINSTALLATIONThermostat Wire TableCAUTIONDo not wire millivolt wall thermostat wiresto 120V wire.WALL SWITCH1) R

Regency® E21-3 Gas Fireplace Insert3131INSTALLATIONOPERATING INSTRUCTIONSFINAL CHECKBefore leaving this unit with the customer, the installer must en

32 Regency® E21-3 Gas Fireplace Insert32OPERATING INSTRUCTIONSCOPY OF LIGHTING PLATE INSTRUCTIONS 2) Wait fi ve (5) minutes to clear out any gas. If y

Regency® E21-3 Gas Fireplace Insert33MAINTENANCEMAINTENANCE INSTRUCTIONS1) Always turn the gas valve to off before cleaning. For relighting, refer t

34 Regency® E21-3 Gas Fireplace InsertMAINTENANCEREMOVING VALVE ASSEMBLY1) Disconnect the power.2) Shut off the gas.3) Remove top and bottom louve

Regency® E21-3 Gas Fireplace Insert35PARTS LIST311012213335343636BRICK PANEL SET232745838383913174939MAIN ASSEMBLY Part # Description

36 Regency® E21-3 Gas Fireplace InsertPARTS LISTBURNER ASSEMBLY & LOG SET Part # Description 533-574/P Valve

Regency® E21-3 Gas Fireplace Insert37PARTS LIST FLUSH FRONT ASSEMBLY Part # Description Flush Door

38 Regency® E21-3 Gas Fireplace InsertWARRANTYFACEPLATE ASSEMBLY Part # Description 91) 910-330 Fan Spe

Regency® E21-3 Gas Fireplace Insert39WARRANTYRegency Fireplace Products are designed with reliability and simplicity in mind. In addition, our intern

4 Regency® E21-3 Gas Fireplace InsertTABLE OF CONTENTSSAFETY LABELSerial No. Decal ...4REQUIR

Printed in CanadaRegency and Energy are trademarks of FPI Fireplace Products International Ltd.© Copyright 2012, FPI Fireplace Products International

Regency® E21-3 Gas Fireplace Insert5SAFETY LABELThis is a copy of the label that accompanies each Regency® Gas Insert. We have printed a copy of the

6 Regency® E21-3 Gas Fireplace InsertREQUIREMENTS5.08: Modifications to NFPA-54, Chapter 10(2) Revise 10.8.3 by adding the following additional requir

Regency® E21-3 Gas Fireplace Insert7INSTALLATIONBEFORE YOU STARTSafe installation and operation of this appliance requires common sense, however, we

8 Regency® E21-3 Gas Fireplace InsertINSTALLATIONIMPORTANT MESSAGE SAVE THESE INSTRUCTIONSThe Regency® Gas Fireplace must be installed in accordance

Regency® E21-3 Gas Fireplace Insert9INSTALLATION13-1/8” (333mm)Low prole faceplatePOLICY FOR SOLID FUEL BURNING & FACTORY BUILT FIREPLACESThe Re