Regency Hampton GC60 Large Pellet Stove TECHNICAL MANUAL User Manual

Contact your building or fire officials about restrictions and installation inspection requirements in your area. PLEASE READ THIS ENTIRE MANUAL BEFOR

hot enough to cause burns if touched by children. Non-combustible shielding or guards may be required.3. Termination must exhaust above the inlet ele

InstallationoutSide freSh-air connection:This Heater must have adequate air for proper combustion in the room that it is installed.A Fresh-air intake

Figure 10: Corner Installation. Installationmobile home inStallation:(76mm)3"(76mm)3"Wall thimble manufactured by pellet vent manufacturer3&

GC604"(100mm) Exhaust4"(100mm) Pellet Vent Pipe4"(100mm) Pellet Vent Wall Thimble45 Elbow with Screen or Termination CapREFER TO VENT M

Installation8. The pipe must extend at least 12” (30 cm) away from the building. If necessary, bring another length of pipe to th

MAX4'Wall ThimbleHorizontal frame for thimbleClean out TeeWall framingVertical section of 4" vent pipeWall Strap4" 90 Elbow with Screen

(610mm)MIN 24"4' (1220mm) MAXAll around3"MIN Clearance(75mm)3"(76mm) MIN.Rain CapStorm CollarFlashingClean Out TeeWall ThimbleWall

2 ft(61 cm)Rain Cap (ensure cap is at least 3ft (91cm) above the roof at the lowest Roof FlashingRoof RafterFire Stop with Support CollarCeiling Joist

Existing FireplaceClean Out TeeFireplace Damper LocationRain CapSeal PlateVent Pipe (single wall stainless flex pipe or PL vent)Existing Masonary Flu

InstallationSlider/damper Set-up:This is used to regulate the airflow through the pellet stove. Convection FanSlider DamperSlider Damper Set Screw wit

Hampton GC60 Cast Pellet Stove Technical Manual2Safety Note: If this stove is not properly installed, a house re may result. For y

TroubleshootingDO NOT:● Service the stove with wet hands. The stove is an electrical appliance, which may pose a shock hazard if handled improperly.

Troubleshooting• Exhaust Temperature Sensor failure. Bypass sensor located on Exhaust Blower, if stove now operates properly, the unit may require cl

Troubleshooting7. The convection blower will not function normally. • Check the line fuse to see if it has blown.• Clean all grill openings at the b

Wiring DiagramIgnitorRedWhiteRedWhiteAir PumpExhaustTemperatureSensorBrownBrownHigh Limit TemperatureSwitchOrangeOrangePurpleWhiteConvectionBlowerAgit

Parts ListITEM # DESCRIPTION PART #not shownLog Set (optional) GC60-930not shownGlass Tinted (optional) GC60-946not shown 120 CERAMIC EXHAUST TEMP SEN

Parts ListITEM # DESCRIPTION PART #12AUGER BRASS BUSHINGS (2) GF55-04514 FIRE GRATE GC60-01315 AGITATOR DRIVE BRACKET GC60-01416 SS BURN POT LINER GC6

Parts Diagram - Components2622 48195415255253232510443233112449631221204050313942 471587495643515141627461745Hampton GC60 Cast Pellet Stove Technical

Parts Diagram - CASTITEM # DESCRIPTION PART #57 GC60 CAST FRONT - CHARCOAL GC60-20158 GC60 CAST TOP - CHARCOAL GC60-21159 GC60 CAST HOPPER LID - CHARC

Please Note - Burning Corn or Grains - Burning corn or other grains creates a harsher environment than burning wood pellets. The sugar in corn turns t

Hampton GC60 Cast Pellet Stove Technical Manual 29WARRANTYExclusions and Limitations:1. This Warranty does not cover tarnish, discoloration or wear o

Safety Warnings & Recommendations...4Specifications...

Hampton GC60 Cast Pellet Stove Technical Manual30WARRANTY18. The Limited Warranty does not cover tarnish, discoloration or wear on the plated surfaces

Hampton GC60 Cast Pellet Stove Technical Manual 31____________________________________________________________________________________________________

Printed in CanadaRegency, Hampton and Greenfire are registered and / or proprietary trademarks of FPI Fireplace Products International Ltd.© Copyright

Safety Warnings & Recommendations* This manual is designed for the technician in conjunction with the owner’s manual. *Please read this entire Tec

Safety Warnings & RecommendationsELECTRICAL: The use of a surge protected power bar is recommended. The unit must be grounded. The grounded electr

Specificationsrating label & location:The rating label is located on the label plate on the back of the unit.Certified for use in Canada & USA

SpecificationsdimenSionS:28.4"(722mm)31.7"(806mm)29.4"(748mm)23"(584mm)28.7"(729mm)18.5"(470mm)28"(713mm)Figure 2:

REPLACE THESE SCREWS AFTER REMOVING FROM PALLET. (2 EACH SIDE)Installationdeciding Where to locate your pellet appliance:1. Do not install the stove i

InstallationclearanceS to combuStibleS:(229mm)9"(76mm)3"(76mm)3"Side WallBack WallAdjacent WallThese dimensions are minimum clearances